Sheet Size: 15.5"X21"
Durable 1mm thick Gel adhesive on the garment side
Lasts for several months
Lint can be cleaned off with water and a scrub pad
PalletGel changes color from green to yellow when your pallets are warmed to 120F
Warm/Preheated Pallets:
- Allow ink to flow through mesh smoothly
- Help prevent ink from sticking to the bottom of your screens
- Ensure consistency so your first print will be like your last
- Speed up flash time
PalletGel is applied directly to the pallets
No need for paper pallet tape
Film release liners on both sides
Allow for a smooth application
Step 1: Clean the Pallets
PalletGel sticks best to clean and dry pallets.
Step 2: Apply PalletGel
Apply the back edge of PalletGel directly to your pallet. While holding the opposite end of PalletGel up and off of the pallet, use a squeegee card or something rigid to squeegee PalletGel onto the pallet. Take your time here to avoid air bubbles. PalletGel will be on your pallets for a while.
​Step 3: Tape the Edges *Important
Remove the top release liner from PalletGel and use masking tape to tape down all four sides of PalletGel to the pallets. This will help shirts slide on and off of the pallets easily. It will also ensure PalletGel doesn't lift over time.
Clean as Needed
Clean lint off of PalletGel with water and a scrub pad. Once the water evaporates, PalletGel is sticky again. If you get ink on PalletGel, use on press cleaner to remove the ink.