Create a "Cracking" effect. The ink surface stiffens and breaks vertically and horizontally creating the cracking effect.
Recommended Fabrics
100% Cotton
Ink Application
If additives are needed, select from the suitable additives below (all additives listed are Formaldehyde and Phthalate Free):
- Reduce Viscosity: Add 3% of HYDRA REDUCER 120
- Further Improve Screen Stability: Add 3-5% HYDRACRYL RETARDER
Mesh Count
Up to 83 t/in
Emulsion
Any direct or indirect water resistant emulsion
Recommended: CP Tex Emulsion, for use with water based and plastisol inks.
Squeegee
60 Durometer Squeegee, Sharp Edge, 25° Angle
Cure Temperature
320°F (160°C) entire ink film for 2 minutes
Clean-Up
ReadyWash™ Ink Degradent specifically designed for water based inks
Storage
Recommended storage at 65°F to 90°F (18°C to 32°C). Avoid storage in direct sunlight. Keep containers well sealed.
**Recommended Pallet Adhesive: ReadyTack™ Pallet Adhesive is designed to be used with water based, discharge and plastisol inks. ReadyTack™ is more cost-effective than aerosol adhesives and will not break down while printing with water based inks, unlike other adhesives available on the market.***