APPLICATION OF READYCHARGE™ Discharge Ink:
This ink is specifically designed to be used directly from the container. DO NOT ADD ADDITIONAL DISCHARGE AGENT.
This will render the ink useless. Crock and wash fastness should be
tested prior to printing any fabrics. If screens are to be left idle for
long periods of time, remove ink from the print area and clean the
image area with water.
RECOMMENDED FABRICS: 100% Cotton fabrics
MESH: 156-230 mesh for best results
EMULSION: Use of a quality direct water resistant emulsion that
has been properly exposed. READYCHARGE™ INKS feature a slip aid that
reduces squeegee drag, improves screen life, and increases screen open
time without affecting or extending cure time.
SQUEEGEE PARAMETERS (MANUAL PRINTING): A sharp edge with a 60-70
durometer is preferable. These inks do not need to be driven into the
fabric but rather will naturally be drawn into the fabric of the
garment. Leaving the screen flooded in between prints will maintain a
well lubricated mesh.
FLOOD BAR AND SQUEEGEE PRESSURE (AUTOMATIC PRINTING): A 60-70
durometer squeegee with a sharp edge is preferable. If using a triple
durometer squeegee, use a 60/90/60 or a 70/90/70, also with a sharp
edge. Pressure should be adjusted to a medium level. These inks do not
need to be driven into the fabric, but rather will naturally be drawn
into the fabric of the garment. If you see a print on the inside of the
garment, reduce the pressure. Reduce the pressure on the flood bars
also; the ink does not need to be forced into the mesh as a plastisol
does.
FLASHING: Flashing is helpful to reduce the moisture of the under
base, but full discharging or curing of the ink is not required during
the print cycle. Complete discharge will be completed as the plastisol
is cured via the properly set dryer.
CURING: 360°F - 375°F for 2 minutes and 30sec. to 3 minutes
CLEAN-UP: Typically, water will serve as an appropriate solvent
for cleaning the screen and associated tools. In the event of more
difficult clean up situations, a mixture of water and a small amount of common dish soap can be used.
STORAGE OF INKS: READYCHARGE™ INKS are ready to use and designed to maintain full activity with an expected shelf life of several months
when handled and stored properly. These inks are water base and
therefore, evaporation will occur. It is recommended that covers be
returned to containers and tightly sealed when not being used.
Containers should not be stored in direct sunlight or extreme
temperatures. Unused ink can be carded from the screen and returned to
the original container upon completion of print run.
ADDITIONAL IMPORTANT INFORMATION:
READYCHARGE™ INKS are Phthalate compliant and free of AZO, PCP, APEO, and NMP.
READYCHARGE™ INKS are designed to be printed as is, reducing with water
is not recommended. Adding water can adversely affect the inks viscosity
and its ability to completely discharge and may extend cure time.